How to Use Your Automatic Vacuum Rehabilitation Support Kit: A Simple Guide to Controlled Circulatory Therapy

An automatic vacuum pump uses motorised suction to provide controlled and consistent vacuum pressure. It is commonly used for circulatory support, erectile therapy, sensitivity enhancement, and therapeutic penile care.

This guide explains how to safely use an automatic vacuum pump.

Step 1: Clean the Pump Before Use

1. Ensure the device is powered off.

2. Clean the cylinder and rim with the BryCare antibacterial cleaner.

3. Avoid charging ports if the device is not fully waterproof.

4. Rinse gently with warm water.

5. Pat dry with a clean towel.

Always clean before and after each use.

Step 2: Charge or Power the Device

• Fully charge the device
• Never use the pump while charging

Step 3: Apply Lubricant

1. Apply lubricant to your shaft.

2. Apply lubricant to the rim of the pump cylinder.

Lubrication improves comfort and suction control.

Step 4: Position the Pump

1. Place a tension ring at the base of the pump cylinder before pumping, or position it on the cylinder so it can be slid down easily.

2. Insert your shaft into the cylinder.

3. Press the base firmly against the body to create a seal.

4. Ensure comfort before activating suction.

Step 5: Activate Automatic Suction

1. Turn the pump on using the lowest suction setting.

2. Allow the device to apply gentle, controlled suction.

3. Increase intensity slowly only if comfortable.

Suction should always feel gentle and controlled.

Step 6: Apply the Tension Ring

Once firmness has developed, a tension ring may be used to help maintain blood flow.

1. Once firmness is achieved, carefully slide the tension ring from the cylinder onto the base of the shaft.

2. Ensure the ring sits comfortably at the base.

The tension ring helps maintain firmness by reducing the outflow of blood.

Step 7: Use and Timing

• Start with 5–10 minutes per session
• Gradually increase to 10–15 minutes if comfortable
• Use once per day unless advised otherwise

Always turn off and release suction fully before removal.

Step 8: What You Should and Should Not Feel

You should feel:
• Gentle pulling or fullness
• Increased blood flow

You should NOT:
• Feel pain or strong pressure
• Experience numbness or bruising
• Ignore discomfort

Stop use immediately if pain occurs.

Step 9: Time Limits for Tension Rings

Tension rings should never be worn for more than 30 minutes.

Remove the ring immediately if you experience:

• Pain
• Numbness
• Coldness
• Colour changes

Step 10: Remove and Clean After Use

1. Turn the device off.

2. Ensure suction is fully released.

3. Gently remove the pump.

4. Clean, rinse, dry, and store safely.

Key Safety Tips

• Always start on the lowest setting
• Never use while charging
• Use lubricant every time
• Do not exceed recommended use time
• Stop if pain occurs